NT Labs Magiclear

Magiclear

When to use?
When water appears green and/or cloudy. Magiclear causes particles in the water to clump together which can then easily settle out of suspension or be removed by the filter.

How to use?

  • Test the pH and KH of the water.
  • Aerate pond well e.g. fountain, waterfall or air pump. Conduct a partial water change (as much as is practical) before use, especially if the water is extremely green, like “pea soup”.
  • Switch off pump only if strong flow rate could prevent particles from clumping but remember to switch back on as soon as water clarifies.
  • Mix the correct dose in a clean bucket of pond water, then pour evenly around the pond.
  • Clean the collected particles from the filter after treatment.

Without a filter, some clumps may float and can then be removed using a net. Use when you have plenty of time to observe the fish and take action in the unlikely event of a reaction.

Do not:

  • Do not use when the dissolved oxygen may be low (e.g. at daybreak, in hot, humid or thundery weather, or within three hours of feeding).
  • Do not use if the KH is below 6 or the pH is below 7.
  • Do not use if there is nitrite in the water.

Warning:
Failure to conduct a partial water change on extremely green water, like “pea soup”, may result in a rapid reduction in oxygen which could be dangerous to fish! For more information on this subject visit our knowledge hub.

Dosage:

10ml treats 40 gallons.

500ml treats 2000 gallons.

1 litre treats 4000 gallons.

£13.50£19.95

Clear
Category: